Kawasaki Ninja Service Manual: Coolant Reserve Tank Removal

Cooling System Flushing

Over a period of time, the cooling system accumulates rust, scale, and lime in the water jacket and radiator. When this accumulation is suspected or observed, flush the cooling system. If this accu ...

Coolant Reserve Tank Installation

Install the following to the coolant reserve tank [A]. Pad [B] Gasket [C] Cap [D] Collar [E] Install the coolant reserve tank and tighten the bolt [F]. Run the hoses correctly (see Ca ...

Other materials:

Starter Relay Inspection
Remove the front seat (see Front Seat Removal in the Frame chapter). Remove the battery negative (–) cable from the battery negative (–) terminal (see Battery Removal). Take the starter relay [A] off the rear fender. Remove the cover [B]. Remove: Starter Motor Cable [A] ...

Starter Motor Installation
NOTICE Do not tap the starter motor shaft or body. Tapping the shaft or body could damage the motor. Clean the starter motor legs [A] and crankcase where the starter motor is ground. Replace the O-ring [A] with a new one. Apply grease to the new O-ring. Tighten: Torque - Starter ...

Special Tools and Sealant
Compression Gauge, 20 kgf/cm²: 57001-221 Valve Spring Compressor Assembly: 57001-241 Valve Spring Compressor Adapter, 25: 57001-1019 Valve Seat Cutter, 45° - 27.5: 57001-1114 Valve Seat Cutter, 45° - 32: 57001-1115 Valve Seat Cutter, 32° - 28: 57001-1119 Valve Seat Cutter ...