Kawasaki Ninja Service Manual: ESD (Electronic Steering Damper) Actuator Error (Service Code E2E, ZX1000JD/KD)

ESD (Electronic Steering Damper) ECU Communication Error (Service Code 3C, ZX1000JD/KD)

ESD ECU Communication Line Inspection When the data (for status of ESD system) is not sent from the ESD ECU to the meter unit and ECU, the service code 3C is displayed. The data is sent through th ...

ESD Actuator Removal

In this model, ESD actuator is built in the steering damper unit. Refer to the Steering Damper Removal in the Steering chapter. ESD Actuator Installation Refer to the Steering Damper Insta ...

Other materials:

Brake Light Switches
When either the front or rear brake is applied, the brake light goes on. The front brake light switch requires no adjustment, but the rear brake light switch should be adjusted in accordance with the Periodic Maintenance Chart. Inspection Turn the ignition key to “ON”. The brake ligh ...

Evaporative Emission Control System (California model only)
This system routes fuel vapors from the fuel system into the running engine or stores the vapors in a canister when the engine is stopped. Although no adjustments are required, a thorough visual inspection must be made at the intervals specified by the Periodic Maintenance Chart. Inspection ...

Clutch Installation
Apply engine oil to the needle bearing [A] and the sleeve [B]. Install: Needle Bearing Sleeve Install the clutch housing [A]. Fit the holes [B] and projections [C]. Engage the clutch housing gear and the crankshaft primary gear. Install the spacer [A] and the clutch ...