Kawasaki Ninja Service Manual: Evaporative Emission Control System (CAL and SEA-B1 Models)

Kawasaki Ninja Service Manual / Fuel System (DFI) / Evaporative Emission Control System (CAL and SEA-B1 Models)

The Evaporative Emission Control System routes fuel vapors from the fuel system into the running engine or stores the vapors in a canister when the engine is stopped. Although no adjustments are required, a thorough visual inspection must be made at the intervals specified by the Periodic Maintenance Chart.

Fuel Tank Cleaning

WARNINGGasoline and low flash-point solvents can be flammable and/or explosive and cause severe burns. Clean the tank in a well-ventilated area, and take care that there are no spa ...

Parts Removal/Installation

WARNINGGasoline is extremely flammable and can be explosive under certain conditions. Turn the ignition switch OFF. Do not smoke. Make sure the area is well-ventilated and free fro ...

Other materials:

Transmission Assy Assembly
Install the ball bearing [A] until it is bottomed. Turn the oil seal side to the bottom. Special Tool - Bearing Driver Set: 57001-1129 Install the bearing holder [B]. Turn the flat side to the bottom. Apply a non-permanent locking agent to the bearing holder bolts [C]. Tighten: ...

Engine No. ZXT00JE003023
1. Heat Insulation Rubber Plate 2. For Air Switching Valve Hoses (Place the air switching valve above the rubber plate.) 3. For Stick Coils 4. For Throttle Body Assy Holder #2 and #3 5. For Water Temperature Sensor 6. Insert the tab into the slot. 7. For Throttle Body Assy Holder #4 8. ...

Throttle Control System Inspection
Check the throttle grip free play [A]. If the free play is incorrect, adjust the throttle cables. Throttle Grip Free Play Standard: 2 3 mm (0.08 0.12 in.) Check that the throttle grip [B] moves smoothly from full open to close, and the throttle closes quickly and completely by the ...