Kawasaki Ninja Service Manual: Fuel System (DFI)

Spark Plug Replacement

Remove the stick coils (see Stick Coil Removal in the Electrical System chapter). Remove the spark plugs using the 16 mm (0.63 in.) plug wrench [A] vertically. Replace the spark plug with n ...

Exploded View

7. US, CA and CAL Models 8. Immobilizer System Equipped Models 9. ZX1000JD/KD AD: Apply adhesive. L: Apply a non-permanent locking agent. R: Replacement Parts 13. Other than US ...

Other materials:

Thermostat Inspection
Remove the thermostat (see Thermostat Removal). Inspect the thermostat valve [A] at room temperature. If the valve is open, replace the thermostat with a new one. To check valve opening temperature, suspend the thermostat [A] in a container of water and raise the temperature of ...

Wheel Alignment Inspection
Check that the notch [A] on the alignment indicator [B] aligns with the same swingarm mark or position [C] that the other side alignment indicator notch aligns with. If they do not, adjust the chain slack and align the wheel alignment (see Drive Chain Slack Adjustment). NOTE Wheel align ...

Jump starting
If your motorcycle battery is “run down”, it should be removed and charged. If this is not practical, a 12 volt booster battery and jumper cables may be used to start the engine. DANGER Battery acid generates hydrogen gas which is flammable and explosive under certain conditions. It i ...