Kawasaki Ninja Service Manual: Exhaust Butterfly Valve Actuator Removal - Exhaust Butterfly Valve Actuator (Service Code 63)

Never drop the exhaust butterfly valve actuator especially on a hard surface. Such a shock to the actuator can damage it.

If the pulley bolt is removed without holding, the actuator damage will occur.

Exhaust Butterfly Valve Actuator Installation

Install the pulley [A] on the actuator so that the hole side [B] align with the groove [C] on the shaft. Make sure that the groove on the shaft is pointing toward the center of the screw [D]. ...

Other materials:

Bolts, Nuts and Fasteners Tightness Inspection
Check the tightness of the bolts and nuts listed here. Also, check to see that each cotter pin is in place and in good condition. NOTE For the engine fasteners, check the tightness of them when the engine is cold (at room temperature). If there are loose fasteners, retighten them to ...

Throttle Control System Inspection
Check the throttle grip free play [A]. If the free play is incorrect, adjust the throttle cables. Throttle Grip Free Play Standard: 2 3 mm (0.08 0.12 in.) Check that the throttle grip [B] moves smoothly from full open to close, and the throttle closes quickly and completely by the ...

Connecting Rod Bend Inspection
Remove the connecting rod big end bearing inserts, and reinstall the connecting rod big end cap. Select an arbor [A] of the same diameter as the connecting rod big end, and insert the arbor through the connecting rod big end. Select an arbor of the same diameter as the piston pin and ...