Piston Ring End Gap Standard:
Top 0.20 
0.30 mm (0.0079
0.0118 in.)
Second 0.35 
0.50 mm (0.0138
0.0197 in.)
Service Limit: Top 0.6 mm (0.024 in.)
Second 0.8 mm (0.031 in.)
If the end gap of either ring is greater than the service limit, replace all the rings.
Piston Ring Thickness Inspection
BalancerFuel Reserve Switch Inspection
Fill the fuel tank with fuel and close the fuel tank cap.
Remove the front seat (see Front Seat Removal in the
Frame chapter).
Disconnect the fuel pump lead connector [A].
Connect the test light [A] (12 V 3.4 W bulb in a socket
with leads) and the 12 V battery [B] to the fuel pu ...
Spring Preload Adjustment
To adjust the spring preload, turn the spring preload adjuster
[A].
The standard adjuster setting is the 6 turns in from the
fully counterclockwise position.
WARNINGIf both adjusters are not adjusted
equally, handling
may be impaired and a hazardous condition may
result. B ...
Water Pump Housing Disassembly
NOTICE
Do not damage the hole wall of the water pump
housing.
Insert a bar [A] into the pump housing [B], and hammer
evenly around the circumference of the mechanical seal
bottom [C].
Take the oil seal [A] out of the housing [B] with a hook [C].
...