Kawasaki Ninja

Kawasaki Ninja Service Manual: Radiator Hose and Pipe Inspection (coolant leak, damage, installation condition)

Kawasaki Ninja Service Manual / Periodic Maintenance / Periodic Maintenance Procedures / Cooling System / Radiator Hose and Pipe Inspection (coolant leak, damage, installation condition)

The high pressure inside the radiator hose can cause coolant to leak [A] or the hose to burst if the line is not properly maintained.

Replace the hose if any fraying, cracks [B] or bulges [C] are noticed.

Torque - Water Hose Clamp Screws: 3.0 N·m (0.31 kgf·m, 27 in·lb)

Radiator Hose and Pipe Inspection (coolant leak, damage, installation condition)


Coolant Level Inspection
NOTE Check the level when the engine is cold (room or ambient temperature). Check the coolant level in the reserve tank [A] with the motorcycle held perpendicular (Do not use the sidestand). ...

Engine Top End
...

Other materials:

Overview
S-KTRC is a highly sophisticated system based on MotoGP racing technology. Unlike the KTRC system used on the GTR1400 ABS (Concours 14 ABS in N. America), which is designed to offer rider reassurance when traversing slippery surfaces, S-KTRC, is designed to maximize forward motion, allowing ...

Front Fork Assembly
Replace the following parts with new ones. Slide Bushing Guide Bushing Oil Seal Install the following parts to the inner tube [A]. Dust Seal [B] Retaining Ring [C] Apply grease to the oil seal lips. Install the oil seal [A] so that the stamp side faces lower side. Insta ...

Balancer Assemble
Apply molybdenum disulfide oil solution to the ribs of the balancer [A]. Apply molybdenum disulfide oil solution to the ribs of the balancer gear [A]. Check that the rubber dampers [B] are in place. Face the linked portion [C] to the bottom. Assemble the balancer weight ...