Fit the brake pad end into the recess [B] of the caliper holder.
Torque - Rear Brake Pad Pin: 17 N·m (1.7 kgf·m, 13 ft·lb) Rear Brake Pad Pin Plug: 2.5 N·m (0.25 kgf·m, 22 in·lb)
WARNING After servicing, it takes several applications of the brake pedal before the brake pads contact the disc, which could result in increased stopping distance and cause an accident resulting in injury or death. Do not attempt to ride the motorcycle until a firm brake pedal is obtained by pumping the pedal until the pads are against the disc. |
Brake Pad Wear Inspection
Refer to the Brake Pad Wear Inspection in the Periodic Maintenance chapter.
Charging Condition Inspection
Battery charging condition can be checked by measuring
battery terminal voltage with a digital voltmeter [A].
Remove the seat (see Seat Removal in the Frame chapter).
Disconnect the battery terminals.
NOTICE
Be sure to disconnect the negative (–) cable first.
Measure the battery ...
Crankshaft Sensor Peak Voltage Inspection
Refer to the Crankshaft Sensor Peak Voltage Inspection
in the Electrical System chapter.
If the reading is within the standard, remove the ECU and
check the wiring for continuity between harness connectors.
Special Tool - Hand Tester: 57001-1394
Disconnect the ECU and sensor connector ...
Front Fork Installation (Each Fork Leg)
Install the fork so that the top plug end [A] as shown in the
figure.
11 mm (0.43 in.) [B]
Steering Stem Head [C]
Tighten:
Torque - Front Fork Clamp Bolts (Lower): 23 N·m (2.3
kgf·m, 17 ft·lb)
NOTE
Tighten the two lower front fork clamp bolts alternately
two times to ensur ...