Kawasaki Ninja Service Manual: Release Shaft Removal

Kawasaki Ninja Service Manual / Clutch / Clutch Cover / Release Shaft Removal

NOTICE

Do not remove the clutch release lever and shaft assembly unless it is absolutely necessary. If removed, the oil seal replacement may be required.

Release Shaft Removal


Clutch Cover Installation
Using a cleaning fluid, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth. Apply silicone sealant to the area [A] where the mating surf ...

Release Shaft Installation
Apply grease to the oil seal lips on the upper ridge of the clutch cover. Apply engine oil to the needle bearings in the hole of the clutch cover. Applymolybdenum disulfide grease to the pu ...

Other materials:

Odometer
The odometer shows the total distance in kilometers or miles that the vehicle has run. If the odometer is displayed, the “ODO” is displayed on the multifunction display. This meter cannot be reset. A. Odometer B. “ODO” NOTE The data are maintained even if the battery is disco ...

Meter Unit Removal/Installation
Remove the upper fairing assembly (see Upper Fairing Assembly Removal in the Frame chapter) Remove the bolt [A] (other than US, CA and CALmodels). Slide back the dust cover and disconnect the meter unit connector [B]. Remove: Bolts [A] Nut [B] (other than US, CA and CAL mode ...

Oxygen Sensor Removal (Equipped Models)
Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Disconnect the oxygen sensor lead connector [A]. NOTICE Do not pull strongly, twist, or bend the oxygen sensor lead. This may cause the wi ...