Kawasaki Ninja Service Manual: Starter Clutch Removal

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Starter Clutch / Starter Clutch Removal

Starter Clutch Removal


Take care not to drop the starter clutch parts.

Starter Clutch Removal


Starter Clutch
...

Starter Clutch Installation
Replace the O-ring [A] with a new one and apply grease. Apply molybdenum disulfide grease to the starter clutch shaft [B]. Install: Starter Clutch [C] Spacer (Small Diameter) [D] Spacer ...

Other materials:

Exploded View
13. Front Wheel Rotation Sensor B: Apply brake fluid. L: Apply a non-permanent locking agent. R: Replacement Parts S: Follow the specified tightening sequence. Si: Apply silicone grease (ex. PBC grease). 10. Rear Wheel Rotation Sensor B: Apply brake fluid. G: Apply gr ...

Engine Oil Change
Situate the motorcycle so that it is vertical after warming up the engine. Remove the engine oil drain bolt [A] to drain the oil. The oil in the oil filter can be drained by removing the filter (see Oil Filter Replacement). Replace the drain bolt gasket [B] with a new one. Tighten t ...

Tie-Rod and Rocker Arm Bearing Installation
Replace the needle bearings [A] and oil seals with new ones. Apply plenty of grease to the lips of the oil seals. Install the needle bearings and oil seals position as shown in the figure. Screw the needle bearing driver into the driver holder. Insert the needle bearing driver into th ...