Kawasaki Ninja Service Manual: Upper Inner Fairing Installation

Kawasaki Ninja Service Manual / Frame / Fairings / Upper Inner Fairing Installation

Place the tab [A] under the cover as shown in the figure.

Insert the projection [B] into the grommet [C].

Upper Inner Fairing Installation


Upper Inner Fairing Removal
Remove: Quick Rivet [A] Bolt [B] Clear the projection [C] from the hole and remove the upper inner fairing. ...

Center Inner Fairing Removal
Remove: Quick Rivets [A] (Both Sides) Screw [B] Bring the center inner fairing [C] backward to clear the front edge while lift up the upper fairing edges lightly. ...

Other materials:

Spark Plug Replacement
Remove the stick coils (see Stick Coil Removal in the Electrical System chapter). Remove the spark plugs using the 16 mm (0.63 in.) plug wrench [A] vertically. Replace the spark plug with new ones. Standard Spark Plug Type: NGK CR9EIA-9 Insert the spark plug vertically into the sp ...

Instrument display brightness control
The brightness of the tachometer LED segments and illumination of the multifunction meter are controlled automatically depending on the ambient brightness. A. Tachometer B. Ambient Brightness Sensor C. Multifunction Meter NOTE Be careful not to cover the ambient brightness sensor on th ...

Rear Wheel Rotation Sensor Signal Abnormal (Service Code b 44)
Measure the air gap between the rear wheel rotation sensor and sensor rotor. Thickness Gauge [A] Air Gap Standard: 0.4 1.6 mm (0.02 0.06 in.) If the measurement is not the standard, check each part for deformation and looseness and correct accordingly. If the measurement is the sta ...