Kawasaki Ninja Service Manual: Water Pump Impeller Inspection

Water Pump Impeller Disassembly/Assembly

Remove the water pump impeller (see Oil Pump Removal in the Engine Lubrication System chapter). The sealing seat and rubber seal may be removed easily by hand. Apply coolant around the surf ...

Water Pump Housing Disassembly

NOTICE Do not damage the hole wall of the water pump housing. Insert a bar [A] into the pump housing [B], and hammer evenly around the circumference of the mechanical seal bottom [C]. ...

Other materials:

Wheel Inspection
Raise the front/rear wheel off the ground. Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 Spin the wheel lightly, and check for roughness or binding. If roughness or binding is found, replace the hub bearings (see Hub Bearing Removal/Installation). Inspect the wh ...

System Components
1. FI ECU The FI ECU analyzes the motorcycle conditions based on the signals from the front/rear wheel rotation sensors and FI sensors (such as the crankshaft sensor and main throttle sensor), and controls engine power by reducing the number of ignition and retarding the ignition timing. The m ...

Special Tools and Sealants
Outside Circlip Pliers: 57001-144 Piston Pin Puller Assembly: 57001-910 Piston Ring Compressor Grip: 57001-1095 Piston Ring Compressor Belt, 67 79: 57001-1097 Bearing Driver Set: 57001-1129 Liquid Gasket, TB1216B: 92104-1064 Liquid Gasket, TB1207B: 92104-2068 ...