Kawasaki Ninja Service Manual: Wheel Inspection

Kawasaki Ninja Service Manual / Wheels/Tires / Wheels (Rims) / Wheel Inspection

Raise the front/rear wheel off the ground.

Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608
Spin the wheel lightly, and check for roughness or binding.

Wheel Inspection

If roughness or binding is found, replace the hub bearings (see Hub Bearing Removal/Installation).

Inspect the wheel for small cracks, dents, bending, or warp.

If there is any damage to the wheel, replace the wheel.

Remove the wheel, and support it with the tire by the axle.
Measure the rim runout, axial [A] and radial [B], with a dial gauge.

If rim runout exceeds the service limit, check the hub bearings (see Hub Bearing Inspection).

If the problem is not due to the bearings, replace the wheel.

Rim Runout (with tire installed) Standard: Axial TIR 0.5 mm (0.02 in.) or less

Radial TIR 0.8 mm (0.03 in.) or less

Service Limit: Axial TIR 1.0 mm (0.04 in.)

Radial TIR 1.0 mm (0.04 in.)

WARNING

Damaged wheel parts may fail and cause an accident resulting in serious injury or death. Never attempt to repair a damaged wheel part. If the wheel part is damaged, it must be replaced with a new one.

Rear Wheel Installation

Apply high-temperature grease to the grease seal lips. Fit the collars on the both sides of the hub. Left Side Collar [A] Right Side Collar [B] (with Flange) Engage the drive chai ...

Axle Inspection

Remove the front and rear axles (see Front/Rear Wheel Removal). Visually inspect the front and rear axle for damages. If the axle is damaged or bent, replace it. Place the axle in V bloc ...

Other materials:

Transmission Assy Removal
Remove: Engine Sprocket (see Engine Sprocket Removal in the Final Drive chapter) Gear Position Switch (see Gear Position Switch Removal in the Electrical System chapter) Collar [A] O-ring [B] Remove: Clutch (see Clutch Removal in the Clutch chapter) Shift Shaft Assembly ...

Battery Installation
Visually inspect the surface of the battery container. If any signs of cracking or electrolyte leakage from the sides of the battery. Put the battery into the rear fender Install the band [A]. Connect the positive (+) cable [B] (red cap) to the positive (+) terminal first, and then ...

Piston Ring Groove Width Inspection
Measure the piston ring groove width. Use a vernier caliper at several points around the piston. Piston Ring Groove Width Standard: Top [A] 0.82 0.84 mm (0.0323 0.0331 in.) Second [B] 0.82 0.84 mm (0.0323 0.0331 in.) Service Limit: 0.92 mm (0.036 in.) Second 0.92 mm (0.036 in.) ...