Kawasaki Ninja Service Manual: Brakes

Chain Guide Wear Inspection

Remove the swingarm (see Swingarm Removal in the Suspection chapter). Visually inspect the chain guide [A]. Replace the chain guide if it shows any signs of abnormal wear or damage. ...

Brake Fluid Leak (Brake Hose and Pipe) Inspection

For KIBS equipped models, remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Apply the brake lever or pedal and inspect the brake fluid leak from the brake hoses [ ...

Other materials:

ABS and KIBS Indicator Lights (LED) Inspection
In this model, the ABS indicator light (LED) [A] and KIBS indicator light (LED) [B] go on or blink by the data sent from the KIBS hydraulic unit. Refer to the Meter Unit Inspection in the Electrical System chapter. ABS and KIBS Indicator Lights (LED) Function *: The mode of “Low ...

Subthrottle Valve Actuator Inspection
NOTE Be sure the battery is fully charged. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Turn the ignition switch to ON. Check to see that all the subthrottle valves [A] open and close smoothly. Turn the ignition switch to OFF. I ...

Oil Pump Drive Gear Shaft Installation
Apply molybdenum disulfide grease [A] to the oil pump drive gear shaft. Apply molybdenum disulfide oil solution to the followings. Transmission Case [B] Crankcase [C] Install the oil pump drive gear shaft and washer [D] as shown in the figure. Install the new circlip [E] into the ...