Kawasaki Ninja Service Manual: Cooling System

Evaporative Emission Control System Inspection (CAL and SEA-B1 Models)

Inspect the canister as follows. Remove the upper fairing assembly (see Upper Fairing Assembly Removal in the Frame chapter). Remove the canister [A]. Visually inspect the canister for cracks ...

Coolant Level Inspection

NOTE Check the level when the engine is cold (room or ambient temperature). Check the coolant level in the reserve tank [A] with the motorcycle held perpendicular (Do not use the sidestand). ...

Other materials:

Check 3-7 Stop Watch Inspection
Connect the leads in the same circuit as Check 3-2. By pushing the upper button each time to set the stop watch mode. Connect the insulated auxiliary lead processed insulation to the terminal [13] as shown in the figure, then stop watch start to count. While count the stop watch, conn ...

Cable Removal
Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Loosen the nuts [A], and slide the lower end of the clutch cable to give the cable plenty of play. Screw in the ...

Piston Ring, Piston Ring Groove Wear Inspection
Check for uneven groove wear by inspecting the ring seating. The rings should fit perfectly parallel to groove surfaces. If not, replace the piston and all the piston rings. With the piston rings in their grooves, make several measurements with a thickness gauge [A] to determine pisto ...