DFI Power Source
Fuel Pressure InspectionOil Pump Installation
Install the outer rotor [A] into the crankcase.
Assemble:
Oil (Water) Pump Shaft [B]
Pin [C]
Inner Rotor [D]
To prevent dropping, apply grease to the pin.
Install the inner rotor assembly into the crankcase.
Fit the slot [E] onto the projection [F].
Replace the O-ring [A ...
Pressure Testing
Remove:
Upper Fairing Assembly (see Upper Fairing Assembly
Removal in the Frame chapter)
Radiator Cap [A]
Remove the radiator cap in two steps. First turn the cap
counterclockwise to the first stop. Then push and turn it
further in the same direction and remove the cap.
Install the ...
Wiring Diagram (Other than US, CA and CAL without KIBS Models)
ZX1000JC
ZX1000JD
...