Kawasaki Ninja Service Manual: Intake Air Pressure Sensor #2 (Service Code 16)

Water Temperature Sensor Resistance Inspection

Refer to the Water Temperature Sensor Inspection in the Electrical System chapter. If the reading is within the standard, but the problem still exists, replace the ECU (see ECU Removal/Instal ...

Intake Air Pressure Sensor #2 Removal

NOTICE Never drop the intake air pressure sensor #2 especially on a hard surface. Such a shock to the sensor can damage it. Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in t ...

Other materials:

Stick Coil Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the ECU (see ECU Removal in the Fuel System (DFI) chapter). Do not disconnect the ECU connectors. Connect a digital meter [A] to the connector [B] with the needle adapter set. Special Tool - N ...

Water Temperature Sensor Output Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the throttle body assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter). Disconnect the water temperature sensor connector and connect the measuring adapter [A] between these connectors ...

Transmission Shaft Assembly
Apply molybdenum disulfide oil solution to the sliding surfaces of the gears and shafts. Install the gears and the gear bushings [A] with their holes [B] aligned. Replace any circlips removed with new ones. Install the circlips [A] so that the opening [B] of it is aligned with ...