Kawasaki Ninja Service Manual: Intake Air Temperature Sensor (Service Code 13)

Intake Air Pressure Sensor #1 Output Voltage Inspection

Measure the output voltage at the intake air pressure sensor #1 in the same way as input voltage inspection, note the following. Disconnect the intake air pressure sensor #1 connector and c ...

Intake Air Temperature Sensor Removal

NOTICE Never drop the intake air temperature sensor especially on a hard surface. Such a shock to the sensor can damage it. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI ...

Other materials:

Vehicle-down Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Disconnect the vehicle-down sensor connector and connect the measuring adapter [A] between these connectors as shown in the figure. Main Harness [B] Vehicle-down Sensor [C] Special Tool - Measuring Adapte ...

Storage of Removed Parts
After all the parts including subassembly parts have been cleaned, store the parts in a clean area. Put a clean cloth or plastic sheet over the parts to protect from any foreign materials that may collect before re-assembly. Inspection Reuse of worn or damaged parts may lead to serious acci ...

Evaporative Emission Control System (California model only)
This system routes fuel vapors from the fuel system into the running engine or stores the vapors in a canister when the engine is stopped. Although no adjustments are required, a thorough visual inspection must be made at the intervals specified by the Periodic Maintenance Chart. Inspection ...