Kawasaki Ninja Service Manual: Radiator and Radiator Fan Removal

Kawasaki Ninja Service Manual / Cooling System / Radiator / Radiator and Radiator Fan Removal

Radiator and Radiator Fan Removal


Radiator and Radiator Fan Removal


Radiator and Radiator Fan Removal


NOTICE

Do not touch the radiator core. This could damage the radiator fins, resulting in loss of cooling efficiency.

Radiator and Radiator Fan Removal


Radiator
...

Radiator and Radiator Fan Installation
If the radiator bracket [A] was removed, install it. Install the radiator fan to the radiator Tighten the radiator fan mounting bolts. When installing the pad [B], install it so that the upper ...

Other materials:

Chassis Parts Lubrication
Before lubricating each part, clean off any rusty spots with rust remover and wipe off any grease, oil, dirt, or grime. Lubricate the points listed below with indicated lubricant. NOTE Whenever the vehicle has been operated under wet or rainy conditions, or especially after using a high ...

Balancer Installation
Position the crankshaft at #2, 3 positions TDC or at #1, 4 positions TDC. Install the balancer assembly as follows. Align the punch mark [A] on the weight and the projection [B] on the crankcase. Engage the balancer gear and the crankshaft gear. Insert the balancer shaft until it is bot ...

Coupling Bearing Removal
Remove: Coupling Grease Seal Circlip [A] Special Tool - Inside Circlip Pliers: 57001-143 Remove the bearing [A] by tapping from the wheel side. Special Tool - Bearing Driver Set [B]: 57001-1129 ...