Kawasaki Ninja Service Manual: Cooling System

Canister Inspection

Refer to the Evaporative Emission Control System Inspection (CAL and SEA-B1 Models) in the Periodic Maintenance chapter. 1. Green Hoses (Purge) 2. Fittings 3. Canister 4. White Hose ( ...

Exploded View

14. Thermostat 15. Frame No. JKAZXT00JJA003074 or JKAZXCJ1 BA003074 G: Apply grease. HG: Apply high-temperature grease. L: Apply a non-permanent locking agent. R: Replacement Parts ...

Other materials:

Steering Damper Oil Leak Inspection
Visually inspect the steering damper [A] for oil leakage. If the oil leakage is found on it, replace the steering damper with a new one (see Steering Damper Removal/ Installation in the Steering chapter). ZX1000JD/KD [B] ...

Intake Air Temperature Sensor Output Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the intake air temperature sensor connector and connect the measuring adapter [A] between these connectors as shown in ...

Jump starting
If your motorcycle battery is “run down”, it should be removed and charged. If this is not practical, a 12 volt booster battery and jumper cables may be used to start the engine. DANGER Battery acid generates hydrogen gas which is flammable and explosive under certain conditions. It i ...