Kawasaki Ninja Service Manual: Radiator Fan Relay (Service Code 56)

Kawasaki Ninja Service Manual / Self-Diagnosis System / Radiator Fan Relay (Service Code 56)

Stick Coil Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the ECU (see ECU Removal in the Fuel System (DFI) chapter). Do not disconnect the ECU connectors. Con ...

Radiator Fan Relay Removal/Installation
The radiator fan relay is built in the relay box [A]. Refer to the Relay Box Removal in the Electrical System chapter. ...

Other materials:

Drive Chain Slack Inspection
NOTE Check the slack with the motorcycle setting on its sidestand. Clean the chain if it is dirty, and lubricate it if it appears dry. Check the wheel alignment (see Wheel Alignment Inspection). Rotate the rear wheel to find the position where the chain is tightest. Measure the ver ...

Thermostat Inspection
Remove the thermostat (see Thermostat Removal). Inspect the thermostat valve [A] at room temperature. If the valve is open, replace the thermostat with a new one. To check valve opening temperature, suspend the thermostat [A] in a container of water and raise the temperature of ...

Air Intake Duct Assembly (US, CA and CAL Models)
Install the dampers [A] and seal [B] as shown in the figure. Fit the holder [C] to the air intake ducts [D]. Projections [E] and Holes [F] Grooves [G] and Ribs [H] Tighten: Torque - Air Intake Duct Assembly Screws [I]: 1.5 N·m (0.15 kgf·m, 13 in·lb) Turn the plug [J] so that ...