Kawasaki Ninja Service Manual: Rear Brake Pad Removal

Front Brake Pad Installation

Check that the pad spring [A] is in place on the caliper. Push the caliper pistons in by hand as far as they will go. Install the brake pads [A] on the pad spring correctly. Fit the ...

Rear Brake Pad Installation

Check that the pad spring is in place on the caliper. Push the caliper piston in as far as it will go. Install the piston side pad [A] first, and then another pad. Fit the brake pad end into ...

Other materials:

Valve-to-Guide Clearance Measurement (Wobble Method)
If a small bore gauge is not available, inspect the valve guide wear by measuring the valve to valve guide clearance with the wobble method as indicated below. Insert a new valve [A] into the guide [B] and set a dial gauge against the stem perpendicular to it as close as possible to the cy ...

Shift Drum Assembly
Press and insert the ball bearing [A] on the shift drum [B] until it is bottomed. Install: Ball Bearing [C] Dowel Pin [D] and Shift Drum Cam [E] Align the pin with the groove in the shift drum cam. Apply a non-permanent locking agent to the shift drum cam holder bolt [F]. Tight ...

Rear Wheel Rotation Sensor Wiring Inspection (Service Code b 45)
Disconnect the rear wheel rotation sensor lead connector [A] (see Rear Wheel Rotation Sensor Removal in the Brakes chapter). Disconnect the KIBS hydraulic unit lead connector (see KIBS Hydraulic Unit Removal in the Brakes chapter). Check the wiring continuity of the G lead and R ...