Kawasaki Ninja Service Manual: Brakes

Rear Sprocket Warp Inspection

Raise the rear wheel off the ground with the stand so that it will turn freely. Set a dial gauge [A] against the rear sprocket [B] near the teeth as shown in the figure, and rotate [C] the re ...

Exploded View

13. Front Wheel Rotation Sensor B: Apply brake fluid. L: Apply a non-permanent locking agent. R: Replacement Parts S: Follow the specified tightening sequence. Si: Apply silicone gr ...

Other materials:

Spring Plate Free Play Adjustment
NOTE The free play adjustment is performed by replacing the steel plate(s). Measure the clutch spring plate free play (see Clutch Spring Plate Free Play Measurement), and then replace the steel plate(s) which brings the free play within the usable range. Spring Plate Free Play Usable ...

Cable Removal
Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Loosen the nuts [A], and slide the lower end of the clutch cable to give the cable plenty of play. Screw in the ...

Warning Symbols
: The red warning indicator light and the oil pressure warning symbol (  ) goes on whenever the oil pressure is dangerously low or the ignition switch is in the “ON” position with the engine not running, and go off when the engine oil pressure is high enough. Refer to the Mainten ...