Kawasaki Ninja Service Manual: Rear View Mirrors

Kawasaki Ninja Service Manual / Frame / Rear View Mirrors

Rear View Mirror Removal

Rear View Mirror Installation

Mud Guard Installation
Installation is the reverse of removal. Note the following. Run the hose and lead correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). Check the brake line. Apply a ...

Sidestand
...

Other materials:

Rear Wheel Rotation Sensor Signal Abnormal (Service Code b 44)
Measure the air gap between the rear wheel rotation sensor and sensor rotor. Thickness Gauge [A] Air Gap Standard: 0.4 1.6 mm (0.02 0.06 in.) If the measurement is not the standard, check each part for deformation and looseness and correct accordingly. If the measurement is the sta ...

Oil Pump Installation
Install the outer rotor [A] into the crankcase. Assemble: Oil (Water) Pump Shaft [B] Pin [C] Inner Rotor [D] To prevent dropping, apply grease to the pin. Install the inner rotor assembly into the crankcase. Fit the slot [E] onto the projection [F]. Replace the O-ring [A ...

Oil Filter Replacement
Drain the engine oil (see Engine Oil Change). Remove the left lower fairing (see Lower Fairing Removal in the Frame chapter). Remove the oil filter [A] with the oil filter wrench [B]. Special Tool - Oil Filter Wrench: 57001-1249 Replace the filter with a new one. Apply grease t ...