Kawasaki Ninja Service Manual: Sidestand

Rear View Mirrors

Rear View Mirror Removal Refer to the Upper Fairing Assembly Removal. Do not disassemble the rear view mirror with turn signal light. The individual parts are not supplied. Rear View Mirror ...

Sidestand Removal

Raise the rear wheel off the ground with the stand [A]. Remove: Sidestand Switch Bolt [A] Sidestand Switch [B] Remove: Spring [A] Sidestand Nut [B] Sidestand Bolt [C] ...

Other materials:

Front Seat Installation
Installation is the reverse of removal. Note the following. Check that the dampers [A] are in place on the front seat. Install the collars [B] as shown in the figure. Place the seat hooks [A] under the fuel tank bracket [B]. ...

Oil Pump Installation
Install the outer rotor [A] into the crankcase. Assemble: Oil (Water) Pump Shaft [B] Pin [C] Inner Rotor [D] To prevent dropping, apply grease to the pin. Install the inner rotor assembly into the crankcase. Fit the slot [E] onto the projection [F]. Replace the O-ring [A ...

Exploded View
10. US, CA, CAL and AU Models 11. ZX1000JD/KD G: Apply grease. L: Apply a non-permanent locking agent. R: Replacement Parts S: Follow the specified tightening sequence. 1. US, CA and CAL Models 2. ZX1000J Model 3. ZX1000K Model 4. AU Model 5. Face the large diameter side re ...