Kawasaki Ninja Service Manual: Water Temperature Sensor (Service Code 14)

Intake Air Temperature Sensor Resistance Inspection

Remove the intake air temperature sensor (see Intake Air Temperature Sensor Removal). Suspend the sensor [A] in a container of machine oil so that the heat-sensitive portion is submerged. S ...

Water Temperature Sensor Removal/Installation

NOTICE Never drop the water temperature sensor especially on a hard surface. Such a shock to the sensor can damage it. Remove the throttle body assy (see Throttle Body Assy Removal in the ...

Other materials:

Gear Position Indicator
The gear position indicator shows the corresponding gear positions where the transmission is shifted. For example, when the transmission is in 6th gear, “6” is displayed. A. Gear Position Indicator (Normal mode) NOTE If the gear position is in the neutral position, the gear positio ...

Flap and Rear Fender Rear Installation
Installation is the reverse of removal. Note the following. Fit the tab [A] to the slot [B]. Run the seat lock cable [C] between the tool kit case and the turn signal light as shown in the figure. When installing the dampers [A] on the lower pipe [B], install it as shown in the figure. ...

Meter Unit Circuit (ZX1000J Model)
1. Ignition Switch 2. Joint Connector F 3. Stop Watch Button 4. Oil Pressure Switch 5. Crankshaft Sensor 6. Water Temperature Sensor 7. Gear Position Switch 8. Intake Air Temperature Sensor 9. ESD ECU (ZX1000JD/KD) 10. ECU 11. Rear Wheel Rotation Sensor 12. Engine Ground 13. Battery ...