Kawasaki Ninja Service Manual: Air Intake Duct Disassembly (Other than US, CA and CAL Models)

Kawasaki Ninja Service Manual / Fuel System (DFI) / Air Line / Air Intake Duct Disassembly (Other than US, CA and CAL Models)

Air Intake Duct Disassembly (Other than US, CA and CAL Models)


Air Intake Duct Disassembly (Other than US, CA and CAL Models)


Air Intake Duct Disassembly (Other than US, CA and CAL Models)


Air Intake Duct Assembly (US, CA and CAL Models)
Install the dampers [A] and seal [B] as shown in the figure. Fit the holder [C] to the air intake ducts [D]. Projections [E] and Holes [F] Grooves [G] and Ribs [H] Tighten: Torque - Ai ...

Air Intake Duct Assembly (Other than US, CA and CAL Models)
Install the seals [A] as shown in the figure. Fit the projections [A] of the air intake valve to the hole [B] of the air intake ducts. Tighten: Torque - Air Intake Duct Assembly Sc ...

Other materials:

Chassis Parts Lubrication
Before lubricating each part, clean off any rusty spots with rust remover and wipe off any grease, oil, dirt, or grime. Lubricate the points listed below with indicated lubricant. NOTE Whenever the vehicle has been operated under wet or rainy conditions, or especially after using a high ...

Oil Pressure Switch Installation
Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth. Apply silicone sealant to the threads of the oil pressure switch, and tighten it. Sealant - Liquid Gasket, TB1211: 56019-120 Torque - Oil Pressure ...

Stick Coil Installation
Apply a thin coat of grease [A] to the stick coils for easy installation. Insert the stick coils so that the coil heads align with the lines [B] on the cylinder head cover. NOTICE Do not tap the coil head while installing the coil. After installation, be sure the stick coils are ...