Kawasaki Ninja Service Manual: Alternator Cover Installation

Kawasaki Ninja Service Manual / Electrical System / Charging System / Alternator Cover Installation

Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth.
Apply silicone sealant to the alternator lead grommet and crankcase halves mating surface [A] on the front and rear sides of the cover mount.

Sealant - Liquid Gasket, TB1211F: 92104-0004

Check that dowel pins [B] are in place on the crankcase.

Alternator Cover Installation

Replace the alternator cover gasket with a new one.
Install the alternator cover [A] and the clamps [B].

Fit the upper clamp to the side [C] of the alternator cover.

Fit the lower clamp to the stopper [D] of the alternator cover.

Tighten: Torque - Alternator Cover Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Connect the alternator lead connector and run the leads correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter).

Alternator Cover Installation

Alternator Cover Removal

Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Bolt [A] ...

Stator Coil Removal

Remove: Alternator Cover (see Alternator Cover Removal) Holding Plate Bolt [A] and Plate [B] Alternator Lead Grommet [C] Stator Coil Bolts [D] Remove the stator coil [E] from the alternat ...

Other materials:

Steering Damper Oil Leak Inspection
Visually inspect the steering damper [A] for oil leakage. If the oil leakage is found on it, replace the steering damper with a new one (see Steering Damper Removal/ Installation in the Steering chapter). ZX1000JD/KD [B] ...

Rear Wheel Rotation Sensor Signal Abnormal (Service Code b 44)
Measure the air gap between the rear wheel rotation sensor and sensor rotor. Thickness Gauge [A] Air Gap Standard: 0.4 1.6 mm (0.02 0.06 in.) If the measurement is not the standard, check each part for deformation and looseness and correct accordingly. If the measurement is the sta ...

Intake Air Pressure Sensor #1 Removal
NOTICE Never drop the intake air pressure sensor #1 especially on a hard surface. Such a shock to the sensor can damage it. Remove: Air Cleaner Housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Intake Air Pressure Sensor #1 Connector [A] Remove the intake air ...