Kawasaki Ninja Service Manual: Others

Engine Stop Switch Operation Inspection

First Step Set the gear position in the neutral position. Turn the ignition switch to ON. Turn the engine stop switch to stop position [A]. Push the starter button. The engine does not s ...

Chassis Parts Lubrication

Before lubricating each part, clean off any rusty spots with rust remover and wipe off any grease, oil, dirt, or grime. Lubricate the points listed below with indicated lubricant. NOTE When ...

Other materials:

Information for Coolant
To protect the cooling system (consisting of the aluminum engine and radiator) from rust and corrosion, the use of corrosion and rust inhibitor chemicals in the coolant is essential. If coolant containing corrosion and rust inhibitor chemicals are not used, over a period of time, the cooling ...

Exhaust Butterfly Valve Cable Removal
Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Open the clamp [A] and free the cables. Slide the dust covers [B]. Loosen the locknuts [A], and turn the adjusters [B] to give the cable plenty of play. Remove the clamp [A]. Remove the up ...

Rear Master Cylinder Installation
Replace the washers that are on each side of hose fitting with new ones. Install the brake hose [A]. Touch the brake hose to the stopper [B] of the rear master cylinder. Tighten: Torque - Brake Hose Banjo Bolt: 25 N·m (2.5 kgf·m, 18 ft·lb) Install the master cylinder, the brack ...