Kawasaki Ninja Service Manual: Hub Bearing Installation

Hub Bearing Removal

Remove the wheels (see Front/Rear Wheel Removal), and take out the following. Collars Coupling (Out of rear hub) Grease Seals Use the bearing remover to remove the hub bearings [A]. ...

Hub Bearing Inspection

Since the hub bearings are made to extremely close tolerances, the clearance can not normally be measured. NOTE Do not remove any bearings for inspection. If any bearings are removed, they will ne ...

Other materials:

Coolant Change
WARNINGCoolant can be extremely hot and cause severe burns, is toxic and very slippery. Do not remove the radiator cap or attempt to change the coolant when the engine is hot; allow it cool completely. Immediately wipe any spilled coolant from tires, frame, engine or othe ...

Rear Sprocket Removal
Remove the rear wheel (see Rear Wheel Removal in the Wheels/Tires chapter). NOTICE Do not lay the wheel on the ground with the disc facing down. This can damage or warp the disc. Place blocks under the wheel so that the disc does not touch the ground. Remove: Rear Sprocket Nu ...

Throttle Control System Inspection
Check the throttle grip free play [A]. If the free play is incorrect, adjust the throttle cables. Throttle Grip Free Play Standard: 2 3 mm (0.08 0.12 in.) Check that the throttle grip [B] moves smoothly from full open to close, and the throttle closes quickly and completely by the ...