Kawasaki Ninja Service Manual: Meter System Inspection

Meter Operation Inspection

Check 1-1: Switching Inspection Turn the ignition switch to ON and check the following. The all LCD segments [A] appear for 3 seconds. The warning indicator light (Red LED) [B] goes on for 3 ...

Check 2-1: Speedometer Inspection

Using the suitable stand, raise the rear wheel off the ground. Rotate the rear wheel by hand or start the engine. Check that the display changes speedometer. If the display function does n ...

Other materials:

Lower Fairing Installation
Installation is the reverse of removal. Note the following. When installing the pad [A], align the edge of the pad and the marking of the fairing [B]. When installing the pad [C], align the edge of the pad and the fairing [D], and fit the edge of the pad to the boss [E]. Insert the hoo ...

Drive Chain Slack Adjustment
Remove the cotter pin [A], and loosen the rear axle nut [B]. Loosen the both chain adjuster locknuts [C]. If the chain is too loose, turn out the left and right chain adjusters [D] evenly. If the chain is too tight, turn in the left and right chain adjusters evenly, and kick the wheel f ...

Crankshaft Sensor Removal
Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Crankshaft Sensor Lead Connector [A] Remove: Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Bolts [A] Crankshaft Sensor Cover [B] and Gasket Oil Pressure Switch Terminal [C] ...