Kawasaki Ninja Owners Manual: Battery Installation

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Battery / Battery Installation

Place the battery in the battery case.
Connect the (+) cable to the (+) terminal, and then connect the (–) cable to the (–) terminal.

NOTICE

Installing the (–) cable to the (+) terminal of the battery or the (+) cable to the (–) terminal of the battery can seriously damaged the electrical system.

Put a light coat of grease on the terminals to prevent corrosion.
Cover the (+) terminal with the red cap.
Reinstall the removed parts.

Battery Removal

Remove the rider’s seat (see Seats section in the GENERAL INFORMATION chapter). Turn the ignition switch to “OFF” and disconnect the (–) cable from the battery. Remove the red cap ...

Headlight Beam

NOTE Do not turn the bolts because the reflector in the headlight comes off. A. Bolts The left and right adjusters on the headlight can move the direction of the headlight beam to up, d ...

Other materials:

Torque Limiter Removal
Remove: Starter Motor (see Starter Motor Removal in the Electrical System chapter) Throttle Body Assy Holder [A] Breather Hose [B] Roll up the heat insulation rubber plate [C]. Remove: Torque Limiter Cover Bolts [A] Torque Limiter Cover [B] Remove: Torque Limit ...

Fuel Flow Rate Inspection
WARNINGGasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light. Do not smoke. T ...

Idle Speed Control Valve Actuator Installation
Replace the O-ring [A] with a new one. Apply engine oil to the new O-ring. Install the idle speed control valve [A] as shown in the figure. 10° [B] Tighten: Torque - Idle Speed Control Valve Actuator Retainer Screws: 2.06 N·m (0.21 kgf·m, 18 in·lb) Install th ...