Kawasaki Ninja Service Manual: Brake Disc Installation

Kawasaki Ninja Service Manual / Brakes / Brake Disc / Brake Disc Installation

Brake Disc Installation


Brake Disc Installation


Brake Disc Removal
Remove the wheels (see Front/Rear Wheel Removal in the Wheels/Tires chapter). Unscrew the mounting bolts [A], and take off the disc [B]. ...

Brake Disc Wear Inspection
Measure the thickness of each disc [A] at the point where it has worn the most. If the disc has worn past the service limit, replace it. Measuring Area [B] Brake Disc Thickness Standar ...

Other materials:

CAN Communication Line
CAN Communication Line Resistance Inspection In this model, resistors for CAN communication line are built in the ECU [A] and meter unit. Refer to the Meter Unit Inspection in the Electrical System chapter for the resistor in the meter unit. Turn the ignition switch to OFF. Remove: EC ...

Water Temperature Sensor Resistance Inspection
Refer to the Water Temperature Sensor Inspection in the Electrical System chapter. If the reading is within the standard, but the problem still exists, replace the ECU (see ECU Removal/Installation in the Fuel System (DFI) chapter). Water Temperature Sensor Circuit 1. ECU 2. Water T ...

Dimmer Switch
High or low beam can be selected with the dimmer switch. When the headlight is on high beam ( ), the high beam indicator light goes on. High beam.......( ) Low beam.......( ) NOTE When the headlight is on high beam, both headlights go on. When the headlight is on low beam, only one headl ...