Kawasaki Ninja Service Manual: Cylinder Head Cover

Air Switching Valve Installation

Install the air switching valve [A] with hose [B] as shown in the figure. Front [C] Left Side View [D] White Paint [E] Air Switching Valve Operation Test Refer to the Air Sucti ...

Cylinder Head Cover Removal

Remove: Air Suction Valves (see Air Suction Valve Removal) Throttle Body Assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter) Stick Coils (see Stick Coil Removal in the El ...

Other materials:

Hoses and Pipes
Hose Installation Install the hoses and pipes, being careful to follow bending direction. Avoid sharp bending, kinking, flattening or twisting. Run the hoses (see Cable, Wire, and Hose Routing section in the Appendix chapter). Install the clamp [A] as near as possible to the hose end ...

Valve Guide Removal
Remove: Valve (see Valve Removal) Oil Seal Spring Seat Heat the area around the valve guide to 120 150°C (248 302°F), and hammer lightly on the valve guide arbor [A] to remove the guide from the top of the head. NOTICE Do not heat the cylinder head with a torch. This ...

Lower Crankcase Assembly
Install the ball bearing [A] and the oil level inspection window [B] until they are bottomed Apply soap and water solution to the oil level inspection window before installation. Install the new circlip [C]. Apply a non-permanent locking agent to the oil passage plug [D]. Tighten: ...