Kawasaki Ninja Service Manual: Fuel Injector Resistance Inspection

Kawasaki Ninja Service Manual / Fuel System (DFI) / Fuel Injectors / Fuel Injector Resistance Inspection

Fuel Injector Audible Inspection
NOTE Be sure the battery is fully charged. The secondary fuel injectors are operating with following conditions. 1. The engine speed is more than 6 000 r/min (rpm). 2. The throttle openi ...

For Primary Fuel Injectors
Remove the air cleaner housing (see Air Cleaner Housing Removal). Disconnect the primary fuel injector connector [A]. Connect a digital meter to the terminals in each primary fuel i ...

Other materials:

Crankcase Halves Assembly
Install: Crankshaft (see Crankshaft Installation) Connecting Rods (see Connecting Rod Installation) Using a cleaning fluid, clean off any oil or dirt on the mating surface of the crankcase halves. Apply liquid gasket to the mating surface of the lower crankcase half as shown in the fi ...

Air Switching Valve Installation
Install the air switching valve [A] with hose [B] as shown in the figure. Front [C] Left Side View [D] White Paint [E] Air Switching Valve Operation Test Refer to the Air Suction System Damage Inspection in the Periodic Maintenance chapter. Air Switching Valve Unit Test ...

Engine Oil Flow Chart
1. Oil Screen 2. Oil Pump 3. Oil Pressure Relief Valve 4. Oil Filter 5. Oil Pipe 6. Oil Cooler 7. Balancer Oil Passage 8. Main Oil Passage 9. Crankshaft Oil Passage 10. Oil Pressure Switch 11. Camshaft Oil Passages 12. Drive Shaft Oil Passage 13. Output Shaft Oil Passage 14. Starter ...