Kawasaki Ninja Service Manual: Fuel Injectors

Fuel Filter Cleaning

The fuel filter [A] is built into the fuel pump and can not be cleaned or checked. If the fuel filter is suspected of clogging or being damaged, replace it with the fuel pump as a set. Fuel Pu ...

Fuel Injector Audible Inspection

NOTE Be sure the battery is fully charged. The secondary fuel injectors are operating with following conditions. 1. The engine speed is more than 6 000 r/min (rpm). 2. The throttle openi ...

Other materials:

Camshaft Chain Tensioner Installation
Replace the O-ring [A] with a new one. Apply grease to the new O-ring. Release the stopper [B] and push the push rod [C] into the interior of the tensioner body [D] so that the position of the push rod is 3 or 4 notches [E] as shown in the figure. Install the tensioner body so that the ...

Front Fender Removal
Remove: Bolts [A] with Washers (Both Sides) Reflectors (Both Sides, US, CA, CAL and AU Models) Front Fender [B] Take the brake hose off the clamp [C] (both sides). Front Fender Installation Apply a non-permanent locking agent to the front fender mounting bolts. Tighten: ...

Engine No. ZXT00JE003023
1. Heat Insulation Rubber Plate 2. For Air Switching Valve Hoses (Place the air switching valve above the rubber plate.) 3. For Stick Coils 4. For Throttle Body Assy Holder #2 and #3 5. For Water Temperature Sensor 6. Insert the tab into the slot. 7. For Throttle Body Assy Holder #4 8. ...