Kawasaki Ninja Service Manual: Gear Position Switch (Service Code 25)

Kawasaki Ninja Service Manual / Self-Diagnosis System / Gear Position Switch (Service Code 25)

Rear Wheel Rotation Sensor Signal (Service Code 24)
Rear Wheel Rotation Sensor Signal Inspection The rear wheel rotation sensor sends the signal to the ECU through the KIBS hydraulic unit (KIBS equipped models). For other than KIBS equipped models, ...

Gear Position Switch Removal/Installation
Refer to the Gear Position Switch Removal/Installation in the Electrical System chapter. Gear Position Switch Resistance Inspection Refer to the Gear Position Switch Inspection in the Elec ...

Other materials:

Brake Fluid Level Inspection
Check that the brake fluid level in the front brake reservoir [A] is above the lower level line [B]. NOTE Hold the reservoir horizontal by turning the handlebar when checking brake fluid level. If the fluid level is lower than the lower level line, fill the reservoir to the upper lev ...

Thermostat Inspection
Remove the thermostat (see Thermostat Removal). Inspect the thermostat valve [A] at room temperature. If the valve is open, replace the thermostat with a new one. To check valve opening temperature, suspend the thermostat [A] in a container of water and raise the temperature of ...

Turn Signal Switch
When the turn signal switch is pushed to the left ( ) or right ( ), the corresponding turn signals blink on and off. To stop blinking, push the switch in. Horn Button When the horn button is pushed, the horn sounds LAP/Passing Button When the LAP/passing button is pushed, the headlight hi ...