Storage of Removed Parts
After all the parts including subassembly parts have been
cleaned, store the parts in a clean area. Put a clean cloth
or plastic sheet over the parts to protect from any foreign
materials that may collect before re-assembly.
Inspection
Reuse of worn or damaged parts may lead to serious acci ...
Starter Clutch Inspection
Remove:
Torque Limiter Cover (see Torque limiter Removal)
Turn the torque limiter [A] by hand. The torque limiter
should turn forward freely [B], but should not turn backward.
If the starter clutch does not operate as it should or if it
makes noise, go to the next step.
Disassem ...
Shift Fork/Gear Groove Wear Inspection
Measure the thickness of the shift fork ears [A], and measure
the width [B] of the gear grooves.
If the thickness of a shift fork ear is less than the service
limit, the shift fork must be replaced.
Shift Fork Ear Thickness
Standard: 5.7 6.0 mm (0.224
0.236 in.)
Service Limit: 5.6 mm ...