Kawasaki Ninja Service Manual: Electrical System

Kawasaki Ninja Service Manual / Electrical System

Footpeg
Footpeg Height Adjustment The front footpeg can be adjusted within 2 positions in height to suit the rider’s preference. Footpeg [A] Bolts [B] Bolt Holes [C] Footpeg Position 1 [D] ...

Exploded View
5. Other than US, CA, and CAL Models 6. The big diameter side of the dampers faces upward. G: Apply grease. L: Apply a non-permanent locking agent. R: Replacement Parts S: Fol ...

Other materials:

Flap and Rear Fender Rear Installation
Installation is the reverse of removal. Note the following. Fit the tab [A] to the slot [B]. Run the seat lock cable [C] between the tool kit case and the turn signal light as shown in the figure. When installing the dampers [A] on the lower pipe [B], install it as shown in the figure. ...

Connecting Rod Bend Inspection
Remove the connecting rod big end bearing inserts, and reinstall the connecting rod big end cap. Select an arbor [A] of the same diameter as the connecting rod big end, and insert the arbor through the connecting rod big end. Select an arbor of the same diameter as the piston pin and ...

Compression Damping Force Adjustment
The compression damping force adjusters for high and low speeds are located on the gas reservoir at the left side of the rear shock absorber. A. High Speed Adjuster B. Low Speed Adjuster NOTE Turning the high speed adjuster has the low speed adjuster turning. Although the low speed adju ...