Kawasaki Ninja Service Manual: Oil Pressure Switch

Oil Pressure Measurement

Remove: Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Oil Passage Plug [A] Attach the adapter [A] and gauge [B] to the plug hole. Special Tools - Oil Pres ...

Oil Pressure Switch Removal

Remove: Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Engine Oil (Drain, see Engine Oil Change in the Periodic Maintenance chapter) Switch Cover [A] Switch Termin ...

Other materials:

Subthrottle Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter) Disconnect the subthrottle sensor connector and connect the harness adapter [A] between these connectors. Spec ...

Piston Ring Thickness Inspection
Measure the piston ring thickness. Use the micrometer to measure at several points around the ring. Piston Ring Thickness Standard: Top [A] 0.77 0.79 mm (0.0303 0.0311 in.) Second [B] 0.78 0.79 mm (0.0307 0.0311 in.) Service Limit: Top 0.70 mm (0.0276 in.) Second 0.71 mm (0.0280 ...

Jump starting
If your motorcycle battery is “run down”, it should be removed and charged. If this is not practical, a 12 volt booster battery and jumper cables may be used to start the engine. DANGER Battery acid generates hydrogen gas which is flammable and explosive under certain conditions. It i ...