Kawasaki Ninja Service Manual: Oil Pressure Switch Removal

Oil Pressure Switch

...

Oil Pressure Switch Installation

Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth. Apply silicone sealant to the threads of the oil pre ...

Other materials:

Seat Cover Installation
Installation is the reverse of removal. Note the following. When installing the pad [A], install it along the corner [B] as shown in the figure. When installing the pad [C], align the ends [D], along the corner [E], and wrap [F] the upper edge of the seat cover. Install the damper [A] ...

Spark Plug Replacement
Remove the stick coils (see Stick Coil Removal in the Electrical System chapter). Remove the spark plugs using the 16 mm (0.63 in.) plug wrench [A] vertically. Replace the spark plug with new ones. Standard Spark Plug Type: NGK CR9EIA-9 Insert the spark plug vertically into the sp ...

Cylinder Compression Measurement
NOTE Use the battery which is fully charged. Warm up the engine thoroughly. Stop the engine. Remove the spark plugs (see Spark Plug Replacement in the Periodic Maintenance chapter). Attach the compression gauge [A] and adapter [B] firmly into the spark plug hole. Using the startermo ...