Kawasaki Ninja Service Manual: Rear Wheel Rotation Sensor Installation

Rear Wheel Rotation Sensor Removal

NOTICE The wheel rotation sensor should be handled carefully, never struck sharply, as with a hammer, or allowed to fall on a hard surface since the wheel rotation sensor is precision made. Be car ...

Wheel Rotation Sensor Inspection

Remove the front wheel rotation sensor [A] from the front fork. Remove the rear wheel rotation sensor [B] from the caliper bracket. Visually inspect the wheel rotation sensors. Replace t ...

Other materials:

Electrical Wiring
Wiring Inspection Visually inspect the wiring for signs of burning, fraying, etc. If any wiring is poor, replace the damaged wiring. Pull each connector [A] apart and inspect it for corrosion, dirt, and damage. If the connector is corroded or dirty, clean it carefully. If it is da ...

Engine Sprocket Removal
Remove: Engine Sprocket Cover Bolts [A] Engine Sprocket Cover [B] Flatten out the bended washer [A]. Remove the engine sprocket nut [B] and washer. NOTE When loosening the engine sprocket nut, hold the rear brake on. Raise the rear wheel off the ground with the stand. ...

Brake Light Switches
When either the front or rear brake is applied, the brake light goes on. The front brake light switch requires no adjustment, but the rear brake light switch should be adjusted in accordance with the Periodic Maintenance Chart. Inspection Turn the ignition key to “ON”. The brake ligh ...