Kawasaki Ninja Service Manual: KIBS (Equipped Models)

Kawasaki Ninja Service Manual / Brakes / KIBS (Equipped Models)

Brake Hose
Brake Hose Removal/Installation Refer to the Brake Hose and Pipe Replacement in the Periodic Maintenance chapter. Brake Hose Inspection Refer to the Brake Hose and Pipe Damage and Install ...

Parts Location
NOTE The front and rear wheel rotation sensors and rotors are standard parts of this motorcycle. Front Wheel Rotation Sensor [A] Front Wheel Rotation Sensor Rotor [B] Rear Wheel Rotation Sens ...

Other materials:

Special Tools
Bearing Puller: 57001-135 Head Pipe Outer Race Press Shaft: 57001-1075 Steering Stem Nut Wrench: 57001-1100 Bearing Driver Set: 57001-1129 Steering Stem Bearing Driver, 42.5: 57001-1344 Steering Stem Bearing Driver Adapter, 41.5: 57001-1345 Head Pipe Outer Race Driver, 55: 57001- ...

Vehicle-down Sensor Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Disconnect the vehicle-down sensor connector and connect the measuring adapter [A] between these connectors as shown in the figure. Main Harness [B] Vehicle-down Sensor [C] Special Tool - Measuring Adapte ...

Starter Clutch Removal
Remove: Torque Limiter (see Torque Limiter Removal) Transmission Assy (see Transmission Assy Removal) Starter Clutch Shaft Holder Bolt [A] Starter Clutch Shaft Bolt [B] Starter Clutch Shaft Holder [C] Remove the starter clutch shaft [A] using a suitable M8 bolt [B]. Take ...