Kawasaki Ninja Service Manual: Relay Box

Gear Position Switch Inspection

NOTE Be sure the transmission and external shift mechanism are good condition. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the connector [A]. ...

Relay Box Removal

Remove the left fuel tank cover (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the connectors [A]. Pull out the relay box [B] from the rubber protector [C]. NOTE The ...

Other materials:

General Information
All rights reserved. No parts of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic mechanical photocopying, recording or otherwise, without the prior written permission of Quality Assurance Division/Motorcycle & Engin ...

Steering Damper Installation
Install the following parts as shown in the figure. Collar [A] Washer (t = 3.5 mm, 0.14 in.) [B] Steering Damper [C] ( ZX1000JC/KC) Electronic Steering Damper [D] (ZX1000JD/KD) Washer (t = 1.2 mm, 0.05 in.) [E] Apply a non-permanent locking agent to the threads of the steering ...

Intake Air Temperature Sensor Output Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the intake air temperature sensor connector and connect the measuring adapter [A] between these connectors as shown in ...