Kawasaki Ninja Owners Manual: Safe operation

Power mode

The Power mode determines the engine power output characteristics and has three settings. The S-KTRC and the Power mode can be set separately. By combining each setting, the rider can get vario ...

Safe riding technique

The points given below are applicable for everyday motorcycle use and should be carefully observed for safe and effective vehicle operation. For safety, eye protection and a helmet are strongly r ...

Other materials:

Intake Air Pressure Sensor #1 Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Disconnect the intake air pressure sensor #1 connector and connect the measuring adapter [A] between these con ...

For Secondary Fuel Injectors
Remove the fuel tank (see Fuel Tank Removal). Disconnect the injector connector and connect the harness adapter [A] between these connectors as shown in the figure. Main Harness [B] Secondary Fuel Injector #1 [C] Special Tool - Measuring Adapter: 57001-1700 Connect a digital me ...

Engine Sprocket Installation
Replace the sprocket washer and axle cotter pin. Install the engine sprocket onto the output shaft. Apply molybdenum disulfide oil solution to the threads and seating surface of the engine sprocket nut. Tighten: Torque - Engine Sprocket Nut: 145 N·m (14.8 kgf·m, 107 ft·lb) NOTE ...