Kawasaki Ninja Service Manual: Starter Clutch

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Starter Clutch

Torque Limiter Installation
Apply molybdenum disulfide grease to the torque limiter shaft [A]. Install the torque limiter [B], the collar [C] and the shaft. Turn the large-hole end of the shaft to inside as shown in t ...

Starter Clutch Removal
Remove: Torque Limiter (see Torque Limiter Removal) Transmission Assy (see Transmission Assy Removal) Starter Clutch Shaft Holder Bolt [A] Starter Clutch Shaft Bolt [B] Starter Clutch Sha ...

Other materials:

Check 2-1: Speedometer Inspection
Using the suitable stand, raise the rear wheel off the ground. Rotate the rear wheel by hand or start the engine. Check that the display changes speedometer. If the display function does not work, check the following parts. Rear Wheel Rotation Sensor (see Wheel Rotation Sensor Inspe ...

Oil Pressure Relief Valve Inspection
Remove the oil pressure relief valve (see Oil Pressure Relief Valve Removal). Check to see if the valve [A] slides smoothly when pushing it in with a wooden or other soft rod, and see if it comes back to its seat by spring [B] pressure. NOTE Inspect the valve in its assembled stat ...

Idle Speed Control Valve Actuator Removal
NOTICE Never drop the idle speed control valve actuator especially on a hard surface. Such a shock to the actuator can damage it. Remove: Throttle Body Assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter) Idle Speed Control Valve Actuator Retainer Screws [A] Idle Spe ...