Rocker Arm/Tie-Rod Bearing, Sleeve Inspection
NOTICE
Do not remove the bearings for inspection. Removal
may damage them.
Visually inspect the rocker arm, or tie-rod sleeves [A] and
needle bearings [B].
The rollers in a needle bearing normally wear very little,
and wear is difficult to measure. Instead of measuring,
inspect the ...
Air Switching Valve
Air Switching Valve Operation Test
Refer to the Air Suction System Damage Inspection in the
Periodic Maintenance chapter.
Air Switching Valve Unit Test
Remove the air switching valve (see Air Switching Valve
Removal in the Engine Top End chapter).
Set the hand tester [A] to the × 1 ...
Crankshaft Sensor Inspection
Disconnect the crankshaft sensor lead connector (see
Crankshaft Sensor Removal).
Set the hand tester [A] to the × 10 Ω range and connect it
to the crankshaft sensor lead connector [B].
Special Tool - Hand Tester: 57001-1394
Crankshaft Sensor Resistance
Connections:
Meter (+ ...