Kawasaki Ninja Service Manual: Torque Limiter

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Torque Limiter

Balancer Damper Inspection
Remove the balancer and disassemble the weight and gear assembly. Visually inspect the rubber dampers [A]. If they appear damaged or deteriorated, replace them. ...

Torque Limiter Removal
Remove: Starter Motor (see Starter Motor Removal in the Electrical System chapter) Throttle Body Assy Holder [A] Breather Hose [B] Roll up the heat insulation rubber plate [C]. ...

Other materials:

Stopping the engine
Close the throttle completely. Shift the transmission into neutral Turn the ignition key to “OFF�. Support the motorcycle on a firm, level surface with the side stand. Lock the steering. NOTE The motorcycle is equipped with a vehicle-down sensor, which causes the engine to sto ...

Cleaning Vehicle before Disassembly
Clean the vehicle thoroughly before disassembly. Dirt or other foreign materials entering into sealed areas during vehicle disassembly can cause excessive wear and decrease performance of the vehicle. Arrangement and Cleaning of Removed Parts Disassembled parts are easy to confuse. Arrange ...

Relay Circuit Inspection
Remove the relay box (see Relay Box Removal). Check conductivity of the following numbered terminals by connecting the hand tester and one 12 V battery to the relay box as shown in the figure (see Relay Box Internal Circuit in this section). If the tester does not read as specified, re ...