Kawasaki Ninja Service Manual: Engine Oil and Oil Filter

Kawasaki Ninja Service Manual / Engine Lubrication System / Engine Oil and Oil Filter

WARNING

Vehicle operation with insufficient, deteriorated, or contaminated engine oil will cause accelerated wear and may result in engine seizure, accident, and injury. Check the oil level before each use and change the oil and filter according to the periodic maintenance chart.

Special Tools and Sealant

Oil Pressure Gauge, 10 kgf/cm²: 57001-164 Oil Pressure Gauge Adapter, PT3/8: 57001-1233 Outside Circlip Pliers: 57001-144 Liquid Gasket, TB1211: 56019-120 ...

Oil Level Inspection

Check that the engine oil level is between the upper [A] and lower [B] levels in the gauge. NOTE Situate the motorcycle so that it is perpendicular to the ground. If the motorcycle has just ...

Other materials:

Valve Guide Installation
Apply engine oil to the valve guide outer surface before installation. Heat the area around the valve guide hole to about 120 150°C (248 302°F). NOTICE Do not heat the cylinder head with a torch. This will warp the cylinder head. Soak the cylinder head and heat the oil. Usin ...

Air Intake Duct Assembly (US, CA and CAL Models)
Install the dampers [A] and seal [B] as shown in the figure. Fit the holder [C] to the air intake ducts [D]. Projections [E] and Holes [F] Grooves [G] and Ribs [H] Tighten: Torque - Air Intake Duct Assembly Screws [I]: 1.5 N·m (0.15 kgf·m, 13 in·lb) Turn the plug [J] so that ...

Fuel Tank
The following octane rating gasoline is recommended for the fuel tank. Avoid filling the tank in the rain or where heavy dust is blowing so that the fuel does not get contaminated. A. Tank Cap B. Fuel Tank C. Top Level D. Filler Neck WARNINGGasoline is extremely flammable an ...