Kawasaki Ninja Service Manual: Frame

Rear Fender Front Installation

Installation is the reverse of removal. Note the following. Run the harness, cables and leads correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). When install ...

Rear Frame Rear Removal

Remove: Flap and Rear Fender Rear (see Flap and Rear Fender Rear Removal) Rear Frame Rear Bolts [A] Rear Frame Rear [B] Rear Frame Rear Installation Apply a non-permanent locking agent to ...

Other materials:

Camshaft Removal
Remove: Cylinder Head Cover (see Cylinder Head Cover Removal) Crankshaft Sensor Cover (see Crankshaft Sensor Removal in the Electrical System chapter) Using a wrench on the timing rotor bolt [A], turn the crankshaft clockwise until the line [B] (TDC mark for #1,4 pistons) on the timin ...

Ball Bearing and Needle Bearing
Do not remove pressed ball or needle unless removal is absolutely necessary. Replace with new ones whenever removed. Press bearings with the manufacturer and size marks facing out. Press the bearing into place by putting pressure on the correct bearing race as shown. Pressing the incorrect ra ...

Drive Chain Slack Inspection
Refer to the Drive Chain Slack Inspection in the Periodic Maintenance chapter. Drive Chain Slack Adjustment Refer to the Drive Chain Slack Adjustment in the Periodic Maintenance chapter. Wheel Alignment Inspection/Adjustment Refer to the Wheel Alignment Inspection in the Periodic Maintenance ...